1.【木工】榫钉;夹缝钉;暗销
2.【建】传力杆,合缝钢条
1.用合板钉钉合;用(暗)销接合
2.在...设置传力杆
1.a thick pin made of wood, metal, or plastic, used for holding two pieces of wood, metal, or plastic together
1.Using a pencil sharpener put a point on each end of the wooden dowel(it is not necessary to make a sharp point-bluntwilldo).
使用卷笔刀把上的一个点两端木销子（这是没有必要作出尖锐点钝性将尽）。
2.Bottom Container Plate Dowel Pin Lug A lug attached to the Bottom Container Plate that supports the Dowel Pin Bushing.
装配在底座上，用来支承定位销套的突缘
3.The nonlinear vibration behaviors of a rectangular moderate thickness plate with dowel on elastic foundation were investigated.
研究了弹性地基上带传力杆的间断中厚矩形板结构的非线性振动特性。
4.Objective To compare the long term effectiveness of three types of dowel pin as treatment post core crowning.
目的比较3种类型桩钉作桩核冠修复体的远期疗效。
5.Once your dowels are cut to size, spread a thin layer of glue in all the dowel holes and along the edges of the mating boards.
做好圆榫后，在要对接的两边和榫孔内都涂上薄薄一层胶水。
6.The transverse joints, longitudinal joints, isolation joints, including dowel bar construction technology were introduced too.
介绍横向接缝、纵向接缝、隔离接缝这三种接缝的施工工艺。
7.3-Using small dowels helps with edge joint alignment. Bore the dowel holes with a dowelling jig and an electric drill.
图3。用圆木榫来协助对齐接口。用电钻和圆榫开孔模具来打圆榫孔。
8.There are three rings, shaped spacers that keep the rings above the base with the clock face, and a hardwood dowel rod.
这有三个环，作为基础使得圆环在表盘正上方的支柱，和一根硬木杆。
9.Pull out the jig dowel posts, get your hand into the sound hole and carefully peel away the cardboard jig.
拔出夹具木钉员额，让你的手到健全的漏洞，认真剥离纸板夹具。
10.To that end, this paper analyzes the effect on the concrete pavement behavior of the misalignment of dowel bar.
为此，本文以传力杆出现偏位产生的路面结构力学行为，做为主要的研究内容。