1.【印,纺】喷丝头
2.【动】(蜘蛛,蚕等的)吐丝器
1.a tiny tubular structure, usually one of two pairs, that exudes the fluid produced by the abdominal glands of a silk-producing spider
2.a perforated device for extruding filaments of synthetic fiber
1.The size of the filament depends on the rate of flow through the hole of the spinneret rather than on the size of the hole.
所制成长丝的直径取决于粘胶的喷丝头孔中的流速，而不取决于孔径的大小。
2.The process calls for the chemical to be pushed through the small holes of a spinneret.
要求就是这种化学物质可从喷丝头的小孔里面通过。
3.In this system, the image of the holes on the spinneret were zoomed in and stored for post-processing.
该系统通过显微镜对喷丝孔进行放大成像并采集保存。
4.Nylon is melt spun. That is to say a molten mass of nylon, formed by melting nylon chips, is forced through holes in a spinneret.
尼龙是采用熔纺工艺制成的，即将由熔化的尼龙切片构成的尼龙熔融体，强制通过喷头的纺丝孔。
5.PET POY with different linear density and orientation can be produced with the same spinneret.
利用具有不同孔径的同一喷丝板生产不同线密度和取向度的涤纶POY。
6.Usually the number of holes in the spinneret determines the number of filament in the yarn.
一般喷丝头细孔的数量决定了纱中长丝的根数。
7.Many tiny tubes connect each silk gland with a spinneret.
许多极细小的导管把每个造丝腺体与吐丝器相连。
8.The practical experiments showed that fiber spinnability was optimized when spinneret negative draw ratio was -73%.
工业化试验表明：当喷丝头负拉伸率为-73%时，纤维可纺性达到最佳状态。
9."But if you look at a silkworm, it only has one kind of spinneret, " she added.
“但桑蚕只有一种吐丝器，”她补充说。
10.Design of Spinneret Used for Preparation of Yarn with Different Shrinkage
同板异收缩纤维用喷丝板的设计