1.(=scanning electron microscope)扫描电子显微镜
1.(=scanning electron microscope)
1.SEM micrographs indicate that there existed perfect interfacial adhesion between the surface layer and the substrate one.
对过渡层研究结果表明，复合面层与混凝土基材间的粘接性优异。
2.It was found that there was no reaction between coating layer and aggregate through SEM studies on interfacial transition zone.
通过扫描电镜观察再生粗骨料的界面过渡区，发现涂浆层不与骨料本身反应。
3.SEM observation suggested that the wear mechanism of FEP coatings appeared to be obvious fatigue wear at relatively high temperatures.
在较高的环境温度下，涂层的磨损呈现出明显的疲劳磨损特征。
4.The microstructure of the welding joint was analyzed by SEM, and its corrosion property was tested by an electrochemical system.
利用扫描电镜分析焊接接头微观组织；电化学系统测试接头各区腐蚀速率；
5.The surface morphology of the films were observed by Scan Electron Microscope (SEM) and Atom Force Microscope (AFM) respectively.
用扫描电镜、原子力显微镜观测了非连续多层膜的表面形貌。
6.The surface morphology of the polymer film was examined by scanning electron microscopy (SEM) and atomic force microscopy (AFM).
高分子膜的表面形态采用扫描电子显微镜（SEM）和原子力显微镜（AFM）进行检查。
7.One of each group was remained for veneering porcelain at the end of it, and was observed with SEM and energy spectrum analysis. 3.
每组各留一个试件，上瓷时将瓷烤在金属试件的末端以做扫描电镜和能谱分析。
8.Methods To identify the holistic morphology and the surface ultrastructure characteristic of seeds by scanning electron microscope(SEM).
方法采用扫描电镜观察三种种子的整体形态和种皮表面超微结构特征。
9.STEM and SEM investigations confirm the location of these metal particles is only inside the carbon nanotubes.
使用扫描电镜和扫描透射电镜研究证实金属粒子仅存在于纳米碳管内部。
10.This paper has analyzed the surface and cross-section morphology and the phase composition of the ceramic coatings by using SEM, XRD.
采用SEM、XRD等方法对陶瓷膜的表面微观形貌、结构及成分进行了表征。