3-Fluorobenzenesulfonamide

物化性质

密度：

1.428g/cm3

熔点：

124.5-128.5 °C(lit.)

沸点：

320.5ºC at 760mmHg

闪点：

147.6ºC

折射率：

1.554

蒸汽压：

0.000316mmHg at 25°C

存储条件/存储方法：

常温，避光，通风干燥处

稳定性相关：

常温常压下稳定

其它信息：

1.性状：白色粉末

2.密度（g/mL,15℃）：未确定

3.相对蒸汽密度（g/mL,空气=1）：未确定

4.熔点（ºC）：124.5-128.5

5.沸点（ºC,常压）：未确定

6.折射率：未确定

7.闪点（ºC）：未确定

8.自燃点或引燃温度（ºC）：未确定

9.比旋光度（º）：未确定

10.蒸气压（kPa,25ºC）：未确定

11.饱和蒸气压（kPa,60ºC）：未确定

12.燃烧热（KJ/mol）：未确定

13.临界温度（ºC）：未确定

14.临界压力（KPa）：未确定

15.油水（辛醇/水）分配系数的对数值：未确定

16.爆炸上限（%,V/V）：未确定

17.爆炸下限（%,V/V）：未确定

溶解性：未确定

安全信息

密度：

1.428g/cm3

熔点：

124.5-128.5 °C(lit.)

沸点：

320.5ºC at 760mmHg

闪点：

147.6ºC

折射率：

1.554

蒸汽压：

0.000316mmHg at 25°C

存储条件/存储方法：

常温，避光，通风干燥处

稳定性相关：

常温常压下稳定

其它信息：

1.性状：白色粉末

2.密度（g/mL,15℃）：未确定

3.相对蒸汽密度（g/mL,空气=1）：未确定

4.熔点（ºC）：124.5-128.5

5.沸点（ºC,常压）：未确定

6.折射率：未确定

7.闪点（ºC）：未确定

8.自燃点或引燃温度（ºC）：未确定

9.比旋光度（º）：未确定

10.蒸气压（kPa,25ºC）：未确定

11.饱和蒸气压（kPa,60ºC）：未确定

12.燃烧热（KJ/mol）：未确定

13.临界温度（ºC）：未确定

14.临界压力（KPa）：未确定

15.油水（辛醇/水）分配系数的对数值：未确定

16.爆炸上限（%,V/V）：未确定

17.爆炸下限（%,V/V）：未确定

溶解性：未确定

毒理性

生态数据：

通常对水是不危害的，若无政府许可，勿将材料排入周围环境

MSDS

Material Safety Data Sheet
Section1. Identification of the substance
Product Name:3-Fluorobenzenesulfonamide
Synonyms:
Section2. Hazards identification
Harmful by inhalation, in contact with skin, and if swallowed.
H301:Toxic if swallowed
H311:Toxic in contact with skin
H315:Causes skin irritation
Causes serious eye irritation
H319:
H331:Toxic if inhaled
H335:May cause respiratory irritation
P261:Avoid breathing dust/fume/gas/mist/vapours/spray
P280:Wear protective gloves/protective clothing/eye protection/face protection
P301+P310:IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician
P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present
and easy to do – continue rinsing
P311:Call a POISON CENTER or doctor/physician
Section3. Composition/information on ingredients.
Ingredient name:3-Fluorobenzenesulfonamide
CAS number:1524-40-9
Section4. First aid measures
Skin contact:Immediately wash skin with copious amounts of water for at least 15 minutes while removing
contaminated clothing and shoes. If irritation persists, seek medical attention.
Immediately wash skin with copious amounts of water for at least 15 minutes. Assure adequate
Eye contact:
flushing of the eyes by separating the eyelids with fingers. If irritation persists, seek medical
attention.
Inhalation:Remove to fresh air. In severe cases or if symptoms persist, seek medical attention.
Ingestion:Wash out mouth with copious amounts of water for at least 15 minutes. Seek medical attention.
Section5. Fire fighting measures
In the event of a fire involving this material, alone or in combination with other materials, use dry
powder or carbon dioxide extinguishers. Protective clothing and self-contained breathing apparatus
should be worn.
Section6. Accidental release measures
Personal precautions: Wear suitable personal protective equipment which performs satisfactorily and meets local/state/national
standards.
Respiratory precaution:Wear approved mask/respirator
Hand precaution:Wear suitable gloves/gauntlets
Skin protection:Wear suitable protective clothing
Eye protection:Wear suitable eye protection
Methods for cleaning up: Mix with sand or similar inert absorbent material, sweep up and keep in a tightly closed container
for disposal. See section 12.
Environmental precautions: Do not allow material to enter drains or water courses.
Section7. Handling and storage
Handling:This product should be handled only by, or under the close supervision of, those properly qualified
in the handling and use of potentially hazardous chemicals, who should take into account the fire,
health and chemical hazard data given on this sheet.
Storage:Store in closed vessels.
Section8. Exposure Controls / Personal protection
Engineering Controls: Use only in a chemical fume hood.
Personal protective equipment: Wear laboratory clothing, chemical-resistant gloves and safety goggles.
General hydiene measures: Wash thoroughly after handling. Wash contaminated clothing before reuse.
Section9. Physical and chemical properties
Not specified
Appearance:
Boiling point:No data
Melting point:No data
Flash point:No data
Density:No data
Molecular formula: C6H6FNO2S
Molecular weight: 175.2
Section10. Stability and reactivity
Conditions to avoid: Heat, flames and sparks.
Materials to avoid: Oxidizing agents.
Possible hazardous combustion products: Carbon monoxide, nitrogen oxides, hydrogen fluoride, sulfur oxides.
Section11. Toxicological information
No data.
Section12. Ecological information
No data.
Section13. Disposal consideration
Arrange disposal as special waste, by licensed disposal company, in consultation with local waste
disposal authority, in accordance with national and regional regulations.
Section14. Transportation information
UN Number:UN2811Class: 6.1Packing group: III
Proper shipping name: TOXIC SOLIDS, ORGANIC, N.O.S. (3-Fluorobenzenesulfonamide)
Section15. Regulatory information
No chemicals in this material are subject to the reporting requirements of SARA Title III, Section
302, or have known CAS numbers that exceed the threshold reporting levels established by SARA
Title III, Section 313.
SECTION 16 - ADDITIONAL INFORMATION
N/A

海关数据

中国海关编码：2935009090

概述：

2935009090 其他磺（酰）胺. 增值税率:17.0% 退税率:9.0% 监管条件:无 最惠国关税:6.5% 普通关税:35.0%

申报要素：

品名, 成分含量, 用途

摘要/Summary：

2935009090 other sulphonamides VAT:17.0% Tax rebate rate:9.0% Supervision conditions:none MFN tariff:6.5% General tariff:35.0%

分子结构与计算化学数据

计算化学数据

1.疏水参数计算参考值（XlogP）:无

2.氢键供体数量:1

3.氢键受体数量:4

4.可旋转化学键数量:1

5.互变异构体数量:无

6.拓扑分子极性表面积68.5

7.重原子数量:11

8.表面电荷:0

9.复杂度:221

10.同位素原子数量:0

11.确定原子立构中心数量:0

12.不确定原子立构中心数量:0

13.确定化学键立构中心数量:0

14.不确定化学键立构中心数量:0

15.共价键单元数量:1